Hyperion X Controller – thermostat

This thermostat is for keepers who need to hold a set temperature in a terrarium, aquarium or similar enclosure, with either heating or cooling. It switches the connected device on and off based on a probe reading, so the keeper does not have to adjust equipment by hand. Setting range is 16 to 42 °C.

Why it matters

• Heating and cooling modes: the output can drive a heater to raise the temperature or a cooling device to lower it.
• Two switching methods: either a hysteresis band of 0 to 5 °C or a switch-on delay of 0 to 150 seconds, selected to suit the setup.
• Probe on a 150 cm cable, so the sensor can be placed inside the enclosure while the controller stays outside.
• Large LCD digits next to the socket make programming and reading values easier.

Specifications

• Temperature range: 16 to 42 °C
• Temperature resolution: 0.1 °C
• Accuracy: ±1 °C
• Hysteresis range: 0 to 5 °C
• Delay range: 0 to 150 seconds
• Power consumption: 3 W
• Maximum connected load: 1100 W
• Probe dimensions: 8 x 40 mm
• Probe cable length: 150 cm
• Power cable length: 100 cm
• Weight: 0.45 kg

What it works with

The controller suits terrarium, aquarium and incubator setups where a heater or cooling unit must follow a set temperature. The universal socket accepts Polish and European plugs, so connected devices do not need an adapter. The 1100 W load limit sets the upper boundary for the equipment that can be connected.