Digital Thermostat & Timer – a thermostat with a programmer

This digital thermostat and timer is intended for reptile and amphibian keepers, as well as aquarists, who need stable temperature control and scheduled operation of heating and other devices in one unit. It replaces manual checking of enclosure temperature by holding the minimum and maximum values you set.

Why it matters

• Separate heating and cooling outputs with independent day and night settings, so the thermostat can follow a daily temperature cycle.
• Adjustable hysteresis and an alarm function that give you control over switching behaviour and warning when temperature leaves the set range.
• Two timer modes: four fixed on/off intervals, or automatic cycles that repeat at set intervals (e.g. every 30 minutes, every 2 hours) for a set run time (e.g. 20 seconds, 20 minutes).
• Three touch buttons for setup. According to the manufacturer, full programming takes about 2 minutes.

Specifications

• Temperature range: -30°C to 90°C
• Reading and programming accuracy: 0.1°C
• Operating accuracy (maximum error): 1°C
• Temperature measurement interval: 5 seconds
• Maximum load: 1200 W (2 x 600 W)
• Sensor cable length: 200 cm
• Power cable length: 150 cm (EU plug with earth)
• Outlet cable length: 200 cm (EU earthed sockets without earth pin)
• Display unit dimensions: 107 x 88 x 38 mm
• Socket unit dimensions: 110 x 63 x 44 mm
• Sensor dimensions: 8 x 8 x 40 mm
• Weight: 0.64 kg

What it works with

The unit controls any heating device, such as heating cables, heat mats, heat bulbs or heat emitters, and aquarium heaters. On the timer outlets it can run foggers, misters, lighting and waterfall pumps. Its 1200 W maximum load covers a typical set of heating devices in a single terrarium or aquarium setup.